|
|||
author | remove search highlighting | ||
---|---|---|---|
posted: 26 Apr 2010 21:25 from: richard_t
click the date to link to this post click member name to view archived images |
Hello I think I might have found a flaw with drawing the wing rail joints on diamond crossings (at least), when the timbering is set to "no timbering". I've been templotting an irregular diamond, with the timbering turned off in the generator. The wing rail joints where visible as I was laying out the templates. I then turned on the timbering (again in the generator), and started to set the individual template's timbers to "no timbering". I then noticed the wing rail joints weren't visible. On setting the timbering for a crossing rail to equalized – constant the wing rail joint for that rail reappeared. Edit: a workaround is to set the timbering for a crossing rail, and then remove the timbers using the "shove timbers function" |
||
Last edited on 26 Apr 2010 21:28 by richard_t |
|||
posted: 30 Apr 2010 19:47 from: richard_t
click the date to link to this post click member name to view archived images |
I think I've found similar with the K-crossing stock rail joints on diamond stock rails. Although on this one, some of the joints come and go, depending on which template is selected in the storage box, and what template is last selected when closing it. Hopefully the following is a screen shot showing two missing joints: 499_301531_200000000.png |
||
Last edited on 30 Apr 2010 20:31 by richard_t |
Please read this important note about copyright: Unless stated otherwise, all the files submitted to this web site are copyright and the property of the respective contributor. You are welcome to use them for your own personal non-commercial purposes, and in your messages on this web site. If you want to publish any of this material elsewhere or use it commercially, you must first obtain the owner's permission to do so. |