Hi Martin,

Am I just getting old and forgetful or did the following happen randomly or did I switch something on?

I selected F7 (Move) and when I pressed the mouse button to activate and actually move the control template, the timbers disappeared and reappeared at the end of the move.

The same happened for Shift-F9, I liked it but can't remember if it's happened before.

I have just tried a few more; F6-Curve, F4_Length, F8-Rotate.

Cheers,

Godders.
__________
message ref: 23128

Godfrey Earnshaw wrote:Am I just getting old and forgetful or did the following happen randomly or did I switch something on?Hi Godders,

You switched on the skeleton mouse draw function.

It also removes the outer edges of the rails, drawing the gauge lines only.





In addition to the F keys shown, you can toggle it on and off quickly by pressing the semi-colon key ;

It's useful if the screen is getting cluttered, or the response is a bit slow.

cheers,

Martin.

__________
message ref: 23129

Hi Martin,

Thank you, I was indeed going through all the function keys on the FK Chart, of course I didn't notice anything happening at the time.

I like it, Thanks again.

Cheers,

Godders.
__________
message ref: 23130